HSC-3 Plane Captain Practice Test

These questions are part of the practice quiz. Start practicing

• What type of hazard does a warning in maintenance documentation usually represent?
• How many elastomeric bearings are used in the HSC-3 aircraft?
• What type of procedures are generally outlined in a "S/E Manual" related to aircraft?
• What is the mixing ratio considered as 'light'?
• Which tool can help stop the tail rotor from spinning aside from a broom?
• What must you do before folding the tail of the aircraft?
• Identify the PMU assigned to engines in aircraft systems.
• What is the minimum wait time after shutdown before checking APU levels?
• Which of the following documents is specifically focused on maintenance procedures for the H60 aircraft?
• For a Turnaround, which discovered code is appropriately used?
• Viscous dampers are considered good at what measurement?
• What is one component of the 00-80T-120 manual?
• How many hydraulic pumps are typically present on the aircraft?
• What does the abbreviation MRC stand for in the context of maintenance procedures?
• What is the waiting period after shutdown before checking the APU oil level?
• Where is one chip detector located in the HSC-3 aircraft?
• In what context would you refer to the term "Hand signals"?
• What is the main mount tire pressure limit for the H60S?
• Which crew member is responsible for the braking during aircraft movement?
• What is the procedure regarding mattresses when the tail wheel is damaged?
• When writing a corrosion MAF, how often should it be submitted after discovery?
• When moving aircraft through a hangar bay, how many personnel are typically required?
• How long is a Turn Around inspection valid for?
• Which document would contain standard practices for safe aircraft operations on the flight deck?
• What are the boost servos in an aircraft responsible for?
• What number of fire detectors is found on each engine of the H60H?
• Which of the following is NOT a method to stop the tail rotor from spinning?
• At what PSI is the rotor brake considered inoperative?
• What does the symbol (C) indicate on a daily deck inspection?
• What does the numeric code 390 signify in the A1-H60CA manual?
• Where can the aircraft be parked without the tail wheel engaged?
• What is the first step in the emergency procedure for a hung droop stop?
• What does the WOW switch signify in aircraft systems?
• What is the effect of exceeding the moderate wind restriction on tie down chains?
• What signal should be given to the pilot during a hot brake incident?
• In the event of a fire, who is responsible for signaling the aircrew?
• What should the stab angle be set at while pushing an aircraft?
• What does the maintenance code 'K' refer to?
• What are the normal wind restrictions for tie down chains on the H60H?
• At what distance is it required to wear a cranial with the engines turned on?
• At what speed do wing walkers need to maintain pace during aircraft movement?
• What is the recommended action when an aircraft experiences a thermal runaway?
• Which PMU is designated for hydraulic systems?
• What is the MIL-PRF specification for hydraulic fluid?
• Viscous dampers are serviceable at what measurement?
• What information is contained in the 4790/141 form?
• In the context of aircraft maintenance, what does a caution indicate?
• What is the final step in the ORM (Operational Risk Management) process?
• Which of the following is crucial for effective cleaning and corrosion control in aviation?
• Who has the authority to authorize a move without brakes?
• What is the servicing limit for the rotor brake?
• Where are the electrical servos found on the aircraft?
• How is a corrosion MAF written in notation?
• How many chip detectors are present in the HSC-3 aircraft?
• What is the pressure limit for the main mount tires on the H60H?
• How many levels of ORM exist?
• What is one of the five steps of ORM?
• What are the wind restrictions for opening the dog house on the H60H?
• How would you describe a note in the context of operational procedures?
• In the case of an external/internal/APU fire response, what should be done after notifying maintenance control?
• What does the term "phase" generally refer to in aircraft maintenance?
• What is the tail tire pressure limit range for an H60H?
• What PMU should be referenced for transmission systems?
• Which emergency equipment should be removed before a wash job?
• Who is qualified to inspect fuel samples?
• How long should you wait after engine shutdown before checking MBG oil level?
• Who among the following can sign for an A-sheet?
• Which manual would you reference for information on aircraft refueling?
• What is the minimum pressure for the APU accumulator?
• How long after shutdown should you wait before checking the engine oil level?
• Which measurement signifies the maximum allowable leakage for viscous dampers?
• What is logged in the Aircraft Discrepancy Book (ADB) under fuel consumption?
• During which situations is it prohibited to enter the rotor arc?
• What are the primary types of servos used in aircraft operations?
• At what distance is it mandatory to wear a cranial when the APU is operating?
• At what distance is it required to wear a cranial when the engines are running?
• What is the correct sequence to shut down the main rotor head during an emergency?
• Identify the MIL-PRF number for transmission fluid.
• What is indicated by the form 4790/60?
• How long should you wait after shutdown before checking the MGB oil level on the hot side?
• What does the form 4790/38 represent?
• What type of towbar is commonly used for aircraft movement?
• What is the third step in the emergency procedures for a hung droop stop?
• When the temperature is below 32F, what should the windshield washer reservoir be filled with?
• How is micro-biological contamination in fuel typically identified?
• What should you do if the aircraft is in an isolated area during a hot brake fire?
• Identify the NATO code for JP-5 fuel.
• What is the minimum size at which viscous dampers are considered ineffective?
• What is the service life of a flex coupling before replacement?
• What materials are required to secure the aircraft after safely landing on mattresses?
• What type of inspection is represented by A1-H60CA-MRC-300?
• Which of the following actions should NOT be done during a thermal runaway event?
• What document provides guidelines for the turnaround of the aircraft?
• What does the discovered code 'J' pertain to in daily maintenance practices?
• How many PDI's are present if the utility pump is installed?
• What is the NATO code assigned to JP-4 fuel?
• What is required before opening the dog house in terms of wind conditions for the H60H?
• What is the maximum number of PDI's possible if the utility pump is not installed?
• What should be done if the fire continues after initial firefighting efforts?
• Which MIL-PRF is associated with engine oil?
• How many personnel are required for an aircraft move of an H60H?
• What is the maximum time soap can remain on an aircraft?
• How long do you wait after shutdown before checking the engine oil level?
• What mixing ratio corresponds to 'normal' usage?
• Why is it important to log fuel consumption in the ADB?
• How many people are required when folding the tail pylon?
• Where is one PDI located in the HSC-3 aircraft?
• At what distance must you wear a cranial when the APU is turned on?
• What is the primary purpose of NATOPS?
• What is the daily work order code used in aircraft maintenance?
• In addition to the primary personnel, when is extra safety required during movement?
• What should be immediately done when there is a wheel brake failure?
• What must be completed prior to moving an aircraft?
• Where can the WOW switch be found?
• What are the initial wind restrictions for tie down chains on the H60H?
• Which two areas on an aircraft are recognized as particularly corrosive?
• What should be done with a second sample if the first fuel sample is bad?
• What is the maximum capacity for the MGB?
• Where are the fire detectors located on the H60H?
• What is the wind restriction for tie down chains rated as moderate on the H60H?
• How long after a move should you wait to take fuel samples?
• What is necessary to confirm before attempting to move an aircraft with hot brakes?
• What equipment is used to ground the aircraft during a tail wheel emergency?
• What is the primary focus of the 00-80T-109 manual?
• What do the mixing ratios 1-1, 1-4, and 1-9 refer to?
• What is the servicing limit for the APU accumulator?
• What is the maximum speed limit for a tow tractor during aircraft movement?
• What is the proper Personal Protective Equipment (PPE) when performing fuel samples?
• Where is the canted bulkhead located on the aircraft?
• What is the approximate distance an aircraft moves after an unexpected stop?
• What are the tail tire pressure limits on the H60S?
• What is the first step in the emergency procedure for a damaged or missing tail wheel?
• What type of document is the 00-80T-96 primarily categorized as?
• Who is authorized to stop an aircraft movement?
• How far does an aircraft move when towed at a speed of 5 mph?
• How should you check the security of an oil cap?
• For an engine post-shutdown fire response, what is the pilot’s first attempt to extinguish the fire?
• What items are logged under oil consumption in the ADB?
• Which of the following tasks cannot sign off an A-sheet?
• What is an inappropriate place to park an aircraft without engaging the tail wheel?
• During a hot brake fire emergency, what is the first step?
• What is one method to stop the tail rotor from spinning?
• When referring to flight deck NATOPS, which aspect is emphasized?
• What must you do before connecting the aircraft to the tractor?
• How many fire detectors are installed on the H60H?
• What is the maximum capacity for the engines?
• What is the appropriate action when a whistle is sounded during aircraft movement?
• What additional items are essential for PPE when handling fuel?
• In normal conditions, what is the tie down chain wind restriction for the H60H?
• What must you use when opening the dog house in windy conditions?
• What is the procedure for a contaminated sample of fuel?
• What is the "can opener" referred to in aircraft terminology?
• How long is a Daily inspection valid for?
• What is the first action to take when approaching an overheated tire?
• How many elastomeric bearings are typically on the main rotor head?
• What is the NATO code for JP-8?
• Which of the following documents contains guidelines for cleaning and corrosion control?
• Which item must be removed prior to commencing a wash job on an aircraft?
• What should you clean the fuel sample kit with?
• How many elastomeric bearings are found on the tail rotor?
• What does a note signify in procedure manuals?
• What should be used as cover for the plane captain during a mishap with a tail wheel?
• What are the wind restrictions for folding the tail pylon on the H60H?
• What does a warning signify in aircraft maintenance?
• What is the primary function of an APU accumulator?
• What is a key precaution to take with personnel during a wheel brake failure?
• Where are most elastomeric bearings located in the HSC-3 aircraft?
• When should a pilot bring the aircraft to a hover during a hot brake fire?
• What role is specifically identified as a safety observer during aircraft movement?
• What measurement indicates good flex couplings?
• Who is responsible for directing the movement of an aircraft?
• How many wing walkers are required during the movement of an aircraft?
• Which of the following is found on an A-sheet?
• What are the five fuel contaminants?
• What specific type of goggles is required during fuel sampling?
• How long can soap remain on an aircraft?
• What is the maximum time duration for leaving soap on an aircraft during cleaning?
• What is the maximum capacity for the coffee can?
• How many PDIs are located on each hydraulic pump in the HSC-3?
• What mixing ratio would be considered 'heavy'?
• How many cargo straps are specified in the emergency procedure for a broken tail wheel?
• What are the wind restrictions for tie down chains classified as heavy on the H60H?